PS-3100 - Signal Flow ^

Figure 1 - Signal Flow

Figure 1 - Signal Flow

CAUTION: BEFORE turning on the synthesizer, CHECK the rear power supply panel VOLTAGE SELECTOR to be sure the voltage setting matches the voltage available in your area.

In fig. 1, the solid lines are the sound signal while the broken lines are the control signal (voltage). Note also that there are actually two sound signal routes: one going to final out (F OUT), the other going to direct out (D OUT).

Since the following explanations are based on the flow chart in figure 1, please refer to the chart while reading and try to tie the two together.

NORMAL SETTING



| ^ | PS-3100 index | PS owner's manual menu |